Before you renovate, please be sure to do a closed water test. Be sure to wait until the waterproof coating dries out.
Here's how to do a closed water test
The first step: block the floor drain
First of all, the pre-prepared sand should be put into a plastic bag to tightly block the floor drain and prevent the stored water from running away. The plastic bag in this picture is a waterproof coating bag. Beginning Xiao Bian also thought that it was specially prepared by the master, and later he said that in general, they would keep the plastic bag after the waterproofing, so as to prepare for the use of the closed water test, everyone can learn from it.
Put a sharp corner into the floor drain, and then put a ring around the floor drain plug tight.
Blocked after the effect.
The second step is to block cement on the door where the water is likely to be full. The floor is very low and it is not needed.
Effect after plugging cement
The third step: release water. Water should be soaked in the entire surface of the water-coating test. Generally, 1 cm is enough, but the water that is afraid of being released will evaporate in the next 48 hours. Therefore, it is 2 centimeters high.
In the figure, a lid is placed on the water column where it directly touches the ground. This is to prevent the water pressure from destroying the water-repellent coating too much, and to be careful to go for 10,000 years.
WC
Then wait for the water to fill two centimeters high, and send a few maps of the effects of full water.
balcony
After 48 hours, the master returned to the door to check the results of the closed water experiment. After checking carefully and confirming that there was no leakage, the house was measured and paid for.
kitchen
Summarize the implementation steps as follows: block the floor drain - block the door (the terrain is much lower will not be used) - release water
Precautions:
1. The floor drain must be kept tight.
2. If the topography is to block cement at the entrance, it must wait for the cement to dry before releasing the water.
3. Put a pot or lid on the place where the water column directly touches the ground.
4. Waterproof coating bags and buckets and lids are all useful. The bags are used to hold the sand to block the floor drains, and the buckets and lids are used to cushion the floor to prevent the water from damaging the waterproof coating.
Entrance decoration children's room decoration paint cement kitchen renderings door renderings toilet decoration renderings toilet doors
China Kitchen Faucet For Ck691,Bathroom Sink Faucets,Wall Mounted Shower Faucets,Deck Mounted Bathroom Mixer, we offered that you can trust. Welcome to do business with us. Their has CK1311691C,CK1359691C,CK7271691C-M7146,CK6351691C,CK5493691C-01-24.This one is surface with plating.It has excellent quality and their use High quality spool.Its quality can be trusted
Kitchen Faucet For Ck691,Bathroom Sink Faucets,Wall Mounted Shower Faucets,Deck Mounted Bathroom Mixer
WENZHOU CHENKAI SANITARY WARE CO.,LTD , https://www.chenkaisanitary.com