The main components of the W-type vortex pump (wind type structure) are 1, the pump body 2, the pump cover 3, the impeller 4, the bracket combination 5, the claw-type flexible coupling 6, the packing gland or A. End Seal End Cover 7, Single End Seal (for wM pumps). w-type vortex pump and motor combined storage - base. Pump inlet and outlet of the direction of oblique up, the bend becomes vertical upward. Impeller on the shaft is free to move axially to ensure that the impeller and the pump body, pump cover on both sides of the axial gap between the equal. The paper pad is allowed to adjust the gap, but the paper pad must be placed outside the asbestos pad at the pump cover outlet. The following for everyone to share W-type vortex pump structure and handling. W Single-stage Cantilever Vortex Pump - Block Diagram W Single-stage Cantilever Vortex Pump - Performance Parameters Installation and Disassembly: 1. Installation ①The pump should not be allowed to bear the weight of the inlet and outlet pipes during installation. Suction pipe should be as short and straight as possible. ② After installation, check the pump shaft and motor shaft concentricity and skew. Concentricity of the inspection method can be used to check the ruler to connect the outermost two of the coupling, the concentricity of not more than 0.1 mm; skew check available calipers check the gap between the two coupling ends along the circumference of the gap, Must not exceed 0.3 mm over the entire circumference. 2. Disassembly and mating sequence: ①Remove the pump cover. ② Remove the impeller using the screw hole on the impeller, and remove the key on the shaft. ③ Remove the pump body and remove the packing gland (if the sealing part is a mechanical seal, press it first) and remove the nut of the single-ended sealing cover. Then remove the pump body. ④ In the case of a mechanical seal, remove the fixing screw and remove it together with the single-ended seal cap before removing the mechanical seal. ⑤ remove the coupling. ⑥ Remove the bearing caps on both ends of the bracket, and then take the shaft out of the bracket together with the rolling bearing and remove the bearing. ⑦ assembly sequence and the reverse order of disassembly, but should pay attention to paper pad to adjust the impeller and the pump body and the pump cover should ensure that the axial gap between the Guangzhou International Expo China Construction Water Fair copyright (2) All are welcome to reprint, please indicate the source and author of: Asian pumps network editor: gogoing (QQ / micro-channel:) starting: http: //beng.liuti.cn/ (service hotline: )
PPS 1.50ml/rev Gear Pump
The External gear pump body material is PPS, the gear is PEEK / PPS, the rest of the pump flow material is Hastelloy, which is mainly used for micro transportation of strong alkaline liquid.
All drives of S series with the same specification can be selected. Please consult the manufacturer for detailed dimensions.
Magnetic drive gear pump is a positive displacement Magnetic Drive Oil Pump which realizes non-contact torque transmission through magnetic driver, so as to replace dynamic seal with static seal and make the pump completely leak free. Chemical gear pump is suitable for petroleum, chemical, pharmaceutical, smelting, electroplating, environmental protection, food, national defense and other industries.
PPS 1.50ml/rev magnetic Gear Pump,Micro magnetic Glue Gelatine Transfer Gear Pump,Pps Materials Low-flow Pressure Gear Pump
Suzhou Macxi Fluid Technology Co.,Ltd. , https://www.macxipump.com