Introduction to integrated ceiling installation method

Integrated ceiling installation method Step 1: Accurately measure the installation area and prepare for installation.

After the hydroelectric entry tile is attached, the area of ​​the ceiling to be installed is accurately measured, and an effect map is determined in advance to determine the position of the device.

Integrated ceiling installation method Step 2: Preparation before installation

The air outlet of the bathroom should be installed before installation. Pay attention to the high air field to prevent the rain from entering. The place where the curtain box needs to be hung needs to be hung in advance. The pipe of the hood should be pre-buried to determine the opening of the hood. Location, owners of electric water heaters need to be installed in advance.

Integrated ceiling installation method Step 3: Install the edge line

Integrated ceiling installation method step four: hit the expansion screw, suspend the boom

Be sure to use 8 booms to ensure overall robustness

Integrated ceiling installation method Step 5: Install the hook, the ceiling is equipped with light steel keel and triangular keel

The main keel is made of 50 widened and thick galvanized paint keel to ensure the smoothness of the entire ceiling to further enhance corrosion resistance. The triangular keel also uses hot-dip galvanized paint keel to enhance corrosion resistance.

Step 6 of the integrated ceiling installation method: press the gusset plate into the joint of the three cross keel, and make sure that they are perpendicular to each other, and ensure a horizontal and vertical line.

Integrated ceiling installation method Step 7: Install the appliance. After installing the electrical appliance, if there is power supply, it is necessary to test the machine on site. Remember that the electrician's privately changed line of the Yuba will cause the Yuba to burn out.

Step 8 of the integrated ceiling installation method: glass rubber edge sealing, overall adjustment.