Timing viewing of FAG bearings is especially important

Source: Bearing network time: 2014-08-22

/*250*250 was created on 2017/12/25*/ var cpro_id = 'u3171089';

FAG bearings remind you to regularly repair mechanical equipment; it is very important to ensure the production. As a fine fitting of mechanical equipment; the timing of the bearing is particularly important. Today we will analyze the key steps of FAG bearing timing inspection. Smooth and clean is very important. Before you look at it, you need to sanitize the machine; then remove the parts around the bearing. The oil seal is a very weak part; therefore, be careful to disassemble it; do not apply excessive force; then carefully check the oil seal and The parts around it; if they have exhibited poor performance; they must be replaced; poor oil seals will cause damage to the bearings and severe equipment stops.
FAG bearings check the smoothing agent with a little bit of smoothing agent between the two fingers; if there are contaminants; can feel it; or apply a thin layer of smoothing agent on the back of the hand; then seal the light to see.
Replace the smoothing agent oil smooth FAG bearing after the old oil is drained; if possible; refill the fresh oil and let the machine rotate at low speed for a few minutes. Try to get the oil to collect the residual contaminants; then vent the Engine oil; the oil is best filtered before use. The smoother FAG bearing used in the replacement of grease should prevent the joint with cotton to any part of the bearing; because of these residual fibers Can be wedged between the rolling elements and form damage; especially the use of small bearings need to pay attention to this problem.
Cover the exposed bearing to check the bearing; do not expose the bearing to contaminants or moisture. If the operation is stopped, the machine should be covered with oil-paper plastic sheet or similar information. If you do not have to disassemble, you can perform the inspection. Remove the unshielded bearing under the scene; remove it with a white spirit by applying a brush; then dry it with a lint-free cloth or blow it with compressed air (focus on not letting the bearing assembly start to rotate) Use a small mirror and a probe used by a similar dentist to view the track surface of the bearing, the holder and the beads. If the bearing is not damaged, it should be based on the smooth explanation provided by the original machine or from pages 204 to 247 of this book. The page's claim is fulfilled and smooth. It is not necessary to remove the bearing with the sealing cover or dustproof, only scrub the external appearance. If the bearing is damaged, it needs to be replaced. The replacement of the bearing during the timed protection period is far better than the selection due to the bearing damage. Itâ€™s more economical to stop losing.

Recommend to friends comments close window

Bearing related knowledge

The rear code of NSK bearing clarifies the characteristics of angular touch ball bearing and the use of pump bearing seal is not resistant to wear, high temperature treatment program grinder static pressure imported bearing repair method bearing type system science angle touch ball bearing

This article links to http://
Please indicate China Bearing Network http://

Previous:Unpacking the door of NSK imported vibrating screen bearing Next:NSK axis and shaft cooperation test

Epoxy potting is a room temperature curing type, heating will accelerate the curing speed. After thoroughly mixing the A component and the B component at a ratio of 2:1 (weight ratio), the product is cured for a certain period of time to form a protection.

The glue has the following characteristics:
The curing block is colorless and transparent, and has good light transmission.
High mechanical strength, not easy to damage
Solvent free, no cure by-product
Stable mechanical and electrical performance between -45 and 120 Â°C

Clear epoxy floor coating

clear epoxy concrete,clear epoxy sealer,clear epoxy for concretev

Jiangmen Kasole Building Materials Co., LTD. , https://www.kasole-paint.com