Two methods for detecting battery power

To check if the power of ordinary zinc-manganese dry batteries is sufficient, there are usually two methods. **The method is to estimate the internal resistance of the battery by measuring the instantaneous short-circuit current of the battery, and then determine whether the battery is sufficient. The second method is to use a current meter in series with a resistor with appropriate resistance to calculate the battery by measuring the discharge current of the battery. Internal resistance, to determine whether the battery is sufficient.
**The advantage of the method is that it is simple. The large current file of the multimeter can directly judge the power of the dry battery. The disadvantage is that the test current is very large, far exceeding the limit value of the allowable discharge current of the dry battery, which affects the dry battery to a certain extent. Service life. The advantage of the second method is that the test current is small, the safety is good, and generally does not adversely affect the service life of the dry battery, and the disadvantage is that it is troublesome.
The MF47-type multimeter was used to test and compare a new No. 2 dry battery and an old No. 2 dry battery by the above two methods. Suppose ro is the internal resistance of the dry battery, RO is the internal resistance of the ammeter. When using the second test method, RF is an additional series resistance with a resistance of 3Ω and a power of 2W.
The measured results are as follows. The new No. 2 battery E=1.58V (measured with 2.5V DC voltage), the internal resistance of the voltmeter is 50kΩ, which is much larger than ro, so it can be approximated that 1.58V is the electromotive force of the battery, or open circuit voltage. When using the ** method, the multimeter sets 5A DC current file, the internal resistance of the meter is RO=0.06Ω, and the measured current is 3.3A. So ro+RO=1.58V÷3.3A≈0.48Ω, ro=0.48-0.06=0.42Ω. With the second method, the measured current is 0.395A, RF+ro+RO=1.58V÷0.395A=4Ω, and the internal resistance of the current 500mA is 0.6Ω, so ro=4-3-0.6=0.4Ω.
When measuring the old No. 2 battery with ** method, first measure the open circuit voltage E=1.2V, the internal resistance of the meter is RO=6Ω, the reading is 6.5mA, the multimeter sets the 50mA DC current file, ro+RO=1.2V÷0.0065A ≈184.6Ω, ro=184.6-6=178.6Ω. Using the second method, the measured current was 6.3 mA, ro + RO + RF = 1.2 V ÷ 0.0063 A = 190.5 Ω, and ro = 190.5-6-3 = 181.5 Ω.
Obviously the results of the two test methods are basically the same. The slight difference in the final calculation results is caused by many factors such as reading error, resistance RF error and contact resistance. This small error does not affect the judgment of the battery power. If the battery to be tested has a small capacity and a high voltage (for example, a 15V, 9V laminated battery), the resistance of the RF should be increased.

PH COB Series

Phlizon COB series Grow Light emits all the wavelengths of light which can be fully absorbed by the plants to create.

Best full Spectrum designed to perfectly match large areas of indoor plants, especially for Medical Plant.

COB + Dual-chip,most efficient spectrum,high PPFD.Two cooling fans with double ball(import from Japan) and big aluminum heat sink to protect the grow lights from high temperature,good cooling,long lifespan.Photosynthesis and promote healthy growth budding and flowering.


1000w/2000w /3000w COB LED Grow Light, it will give you more options when your plants need different strength of illumination.

Grow Lights are a great choice for growers who are dealing with hot HPS lights and want to change to something that's going to run cooler. Although LED Grow Lights do produce heat,the smaller models might not bring up the temperature of your grow space.Even the more powerful models of LED grow lights that produce a lot of heat still have built-in cooling systems to help prevent the heat from beaming directly down onto your plants.


1000w 2000w 3000w 400w led grow light Features

Indoor grow light

COB series, high power branded CREE COB with high Par value and deeper penetration

VEG/BLOOM and STRONGER switches for each grow stage.

Special spectrum for plant growing to increase the yield.

Building to Harvest: Beneficial for seeding to fruiting stage.

Good quality fans with low noise.

Easy to install by minute

Energy Saving, environmental friendly

3 Years Warranty

Compare led grow light to traditional HPS/MH grow light

cob led grow light


WHAT MAKE UP AN EXCELLENT LED GROW LIGHT ?

1.PPFD Value : PPFD is Photosynthetic Photon Flux Density. When you choose a plant light, you should compare the PPFD values of different plant lights. The larger the value, the better the growth of the plant.

2.Actual Power: Because the actual power of the plant light always varies with different conditions, all Amazon sellers use the rated power to describe the power of the product because the rated power is constant. When you pick a LED grow light, the rated power of the plant light is a reference, and more importantly is the actual power.

3.Core Coverage: In addition to the above two, when you choose a plant light, you also need to compare the cover area of different plant lights, of course, the size of the core coverage area. In general, in germination stage, you can hang the plant light higher and the cover area is larger. In flowering stage you can hang the plant light lower and the cover area is smaller because the plant needs more light at this stage. You have to compare different coverage areas to choose the plant light that suits you.

cob led grow light

Detailed images of 1000w 2000w 3000w 400w cob led grow light

1000 watt grow light coverage

COB-2000W-2019-4-20-5

3000w led grow light

Applications

Hydroponics, Horticulture, Agriculture and Greenhouse

Locations: Farm, Exhibition, Garden, Home, Urban, Bonsai, and University Lab

Growth of Fruits, Vegetables, Flowers and so on

Seeding, Rooting, Breeding, Flowering and Fruiting period

cob led grow light


Packaging and Shipping

cob led grow light

Trade Terms

Payment: T/T, L/C, Paypal, 30% deposits before production, 70% balance to be paid before deliverying(Western Union are welcome)

Sample will be delivered within 7 working days.

Discounts are offered based on order quanlityes.

MOQ:sample order are acceptable

Delivery ways:DHL,UPS,FedEx,TNT, door to door,by sea,by air,etc.

PHLIZON LOOKING FOR DISTRIBUTOR ALL OVER THE WORLD

If you are interested in, and

1.own several store for agriculture in your local market

2.or in the business of grow light equipment

3.or good relationship with grower or greenhouse owner

To be a distributor, max support will be offered:

1.price support

2.technical support

3.new product support

4.24 hours after-sales service online


Cob Led Grow Light,Led Grow Light,1000W Led Grow Light,Full Spectrum Led Grow Light

Shenzhen Phlizon Technology Co.,Ltd. , https://www.szledaquariumlight.com

Posted on