Many people will blame the quality of the floor in the actual use of the floor, but the relevant departments use statistics to tell us that more than 50% of these problems are caused by improper laying, only 5% It is the quality problem of the floor itself. Therefore, whether the process of laying the floor is reasonable is very important. The following incorrect laying methods should be avoided to avoid shortening the service life of the floor.
1. The ground is not flat: the uneven ground will make some floors and keels floating, and will sound when pedaling.
2. The keel is not dried: the moisture content of the un-dried wood keel is usually about 25%, and the moisture content of the qualified wooden floor is generally 12%. The humidity difference is too high to make the wooden floor absorb moisture quickly, causing the floor to erect and paint. The face burst. It is the usual practice of the current renovation team to lay the floor first and then carry out other construction on the floor. However, after the floor is laid, it often takes a month or more to polish the paint. During the period, the floor and the surrounding water vapor and chemicals did not provide any isolation measures, which may cause the wooden floor to deform and crack due to the sharp change of water content.
3. Assembled too loose or too tight: the wooden floor will expand or contract with the change of temperature and humidity. Therefore, when laying the floor, the tightness of the wooden floor should be reasonably arranged according to the temperature and humidity of the environment in which the place is used. If it is too loose, the floor will shrink and there will be a large gap. If it is too tight, the floor will erect when it expands.
4, the use of wooden wedges and nails fixed way: the use of wooden wedges and nails in the construction of the fixed way, will cause the wooden wedge and nail contact surface is too small, so the nail holding power is insufficient, it is easy to cause wooden keel Loose, there will be a sound when you step on the floor.
1.with 3000 square meter factory about 35 workshop workers and 25 office workers.
2.More than 20 sets of advanced machines with more than ten years domestic trade experience and international trade experience.
3.Manufacture and supply good quality automatic doors
4.With ISO 9001 Certification and many others certifications
5. Excellent DC brushless motor , high wear-resistant qualities wheels and reasonable structure design makes it more stable, quiet, longer life
6.Our Service system is perfect
Controller Dimensions : 85×124×600mm
Weight :12 kg
Maximun leaf weight :150 kg
Open range : 70°~115°
Closing speed : 10~43 cm/s
Door hold time :0.5~10 seconds
Main Power :AC 220V~250V,50~60 Hz
Maximum current :1A
Maximun motor power:55W
Wait Power :14W
Fuse :Minimum 3.5 ASlow
Operating Temperature : -30℃ ~+50℃
Swing Door,Exterior Swing Door,Aluminium Out Swing Door,Refrigerated Swing Door
Shenzhen Hongfa Automatic Door Co., Ltd. , https://www.hongfadoor.com