Paving tiles should pay attention to matters

1. Paving should be determined according to the paving pattern. If there is a directional pattern, the product should be paved according to the direction of the figure for best results. Special attention should be paid to the fact that some bricks with indistinct texture, such as micro-powder bricks, actually exist. It is also directional, and the general screeder will not notice this detail. When laying the micro-powder brick, he does not pay attention to the direction and is confused.

2. The specifications of the floor angle should be consistent with the specifications of the floor tiles and be attached to the floor tiles. Generally, when the tiles are placed in the living room or bedroom, we always like to lay the corner line of 8-15mm, but many people do not pay attention to specifications, and more Will go to the seams, it is not beautiful.

3, it is best to use stitching paving, at present, many users in paving the floor tiles, the pursuit of paving the appearance of beautiful and without leaving the paving. In fact, the coefficient of thermal expansion and contraction of base layer, adhesive layer, and ceramic tile itself differ greatly when paving floor tiles, and in the case of 1-2 years of thermal and cold stress damage, leaving no seams and paving may cause problems such as swelling and fracture of tiles. . After the occurrence of such problems and re-paving, the ratio of the cost to the cost of the first shop is about 4:1. And there is room for stretching and paving with flexibility, which makes it easy to ensure that patchwork seams are flush and tidy, avoiding deviations caused by minor deviations in brick shape or size, and affecting the overall effect of tile-laying. Leave seams for exterior wall tiles to be 5mm, some culture stones can even stay 1CM, interior wall tiles: 1.5mm, floor tiles: 2-3mm, antique tiles 3-5mm, antique tiles with some special effects to stay 5-10MM.

4, tile laying order. Wall tiles should be laid up from the bottom, need to be soaked in clean water for at least thirty minutes, the shade can be paved, of course, the current antique brick wall or polished brick wall is not soaked, that is to say, high water absorption The product needs to be soaked and then paved; the ratio of wall cement to sand is 1 to 4, and the ratio of ground cement to sand is 1 to 3.

Third, after paving

1. After laying for 1 hour, the cement, sealant, or other sticky objects left on the brick surface should be wiped clean, because it is difficult to clean after four hours like the joint filling agent.

2. After laying for 12 hours, tap the brick surface for inspection. If any empty drums are found, re-lay it out.

3, brick paving can be walked after 24 hours, thoroughly scrubbed with clean water mixed with detergent, thoroughly clean the tiles.

Tile Tiles Cement Antique Tiles Exterior Tiles Bedroom Tiles Specifications